VMware SOFTWARE REPOSITORY FOR WINDOWS 1.1 Bedienungsanleitung PDF herunterladen (Seite 51)

Veeam Backup & Replication installation

Server component install on VBR

1. Build the VBR VM, this follows the usual boot from CDROM with floppy attached

method used for all the Lab Windows VMs. You should have the basic AutoLab setup built

with DC, VC and two ESXi servers. On a Workstation environment with 8GB of RAM you

will need to shut down one of the ESXi servers to free some RAM.

2. Logon to VBR as the Veeam service account user lab\svc_veeam

3. On the build share locate B:\VeeamBR\Veeam_B&R_Setup_x64.exe and Run as

Administrator

4. If you are installing Veeam Backup & Replication 6.5, you will see a warning about some

pre-requisites, click Yes and the installer will install these for you.

5. Accept the warning about vCPU count and proceed on through the wizard

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 67 68

Keine Kommentare

VMware SOFTWARE REPOSITORY FOR WINDOWS 1.1 Bedienungsanleitung Seite 51