
Configure the Object Section 8 Monitoring VMware vSphere ESX(i)
82 3BSE056141-510 F
6. In the IT Faceplate aspect, select the Configuration tab enter the IP address of
the server, the SNMP community string, and the IP address of the IMM
Module.
Configure the Object
1. Select the IT Device Manager aspect and press Populate.
2. On each of the following aspects, select the Config View, and Load the
Configuration to the AO Sever:
a. Device Connection
b. System Health Status
3. Select Alarm list - Configure - Open.
4. Select all categories.
5. Press Apply.
Monitoring SNMP Traps in ESXi Server
System 800xA supports virtualization for a physical server, running on VMware
ESXi. ESXi is installed either on to the hard disk, SD card or USB stick. Many
servers have facilities to mount these on circuit boards inside the chassis. ESXi does
not support the service console (and does not support any management software)
that is available in ESX. Therefore, monitoring ESXi server hardware using PC,
Network and Software Monitoring (PNSM) server is not possible.
Similar to ESXi, SAN devices do not support installing additional SNMP
management software. In order to monitor the ESXi server hardware and SAN
devices in the System 800xA, SNMP trap support is now a feature of PNSM.
SNMP Trap is a message that is initiated by an IT Asset (agent) and sent to the
network management system (manager). If an event has occurred, the agent
communicates it to the manager using the Trap. Traps are sent asynchronously and
not in response to the queries from the manager. The manager is responsible for
Kommentare zu diesen Handbüchern