VMware vCenter Site Recovery Manager 4, 1 CPU Spezifikationen PDF herunterladen (Seite 22)

EVALUATOR’S GUIDE

VMWA RE VCENTER SI TE RECO VERY MANAGER 4.0

4. To configure mapping for a resource, right-click it in the Protected Site Resources column and click

Configure.

5. Expand the top-level folder in the Configure Inventory Mapping window and navigate to the recovery

site resource (network, resource pool, or folder) to which you want to map the protected site resource

you selected in Step 4. Select the resource and click OK.

The selected resource is displayed in the Recovery Site Resources column, and its path relative to the

root of the recovery site vCenter is displayed in the Recovery Site Path column.

The following table summarizes the mapping that was created in this environment:

RESOURCE TYPE PROTECTED SITE RESOURCE RECOVERY SITE RESOURCE

Network VM Network VM Network

  Site1Recovery

Folder  Site1Recovery

Figure 16: Inventory Mapping interface after mappings

6. To undo an inventory mapping, right-click it and click Remove.

Step 4: Set up protection group

Site Recovery Manager organizes virtual machines into protection groups based on the datastore group that



failover together.

To create a protection group, you select a datastore group, and then specify a non-replicated datastore at the

recovery site where Site Recovery Manager can create placeholders for members of the protection group. The

placeholder datastore should be accessible to all hosts in the recovery cluster. It should not be replicated and

can be relatively small.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 64 65

Keine Kommentare

VMware vCenter Site Recovery Manager 4, 1 CPU Spezifikationen Seite 22